西宁市典型开放源颗粒物粒径组成特征分析

采用BT-9300S激光粒度仪分析了西宁市道路尘、扬尘、土壤尘、建筑尘4种典型开放源的粒径组成。结果表明,4种类型尘中大粒径颗粒物占主导地位,粒径大于10 μm颗粒占到全部颗粒的73.80%以上,可吸入颗粒物的含量仅占7.06%～26.20%;建筑尘的细颗粒物含量最高,粒径小于2.5、1 μm的颗粒含量分别为8.36%±4.25%、2.42%±1.02%;道路尘的细颗粒物含量最低,粒径小于2.5、1 μm的颗粒含量分别为2.30%±0.94%、0.73%±0.28%;4种类型尘的体积平均直径、面积平均直径、中位直径分别在37.70～87.99 μm、8.50～23.53 μm、28.95～74.98 μm之间,其中道路尘的3种粒径参数最大,建筑尘最小;开放源颗粒物的粒度分布曲线主要呈头长尾短的不对称单峰分布,累积频率曲线为两段式,存在较为明显的拐点。     

Bacterial toxicity comparison between nano- and micro-scaled oxide particles

Toxicity of nano-scaled aluminum, silicon, titanium and zinc oxides to bacteria (Bacillus subtilis, Escherichia coli and Pseudomonas fluorescens) was examined and compared to that of their respective bulk (micro-scaled) counterparts. All nanoparticles but titanium oxide showed higher toxicity (at 20 mg/L) than their bulk counterparts. Toxicity of released metal ions was differentiated from that of the oxide particles. ZnO was the most toxic among the three nanoparticles, causing 100% mortality to the three tested bacteria. Al₂O₃ nanoparticles had a mortality rate of 57% to B. subtilis, 36% to E. coli, and 70% to P. fuorescens. SiO₂ nanoparticles killed 40% of B. subtilis, 58% of E. coli, and 70% of P. fluorescens. TEM images showed attachment of nanoparticles to the bacteria, suggesting that the toxicity was affected by bacterial attachment. Bacterial responses to nanoparticles were different from their bulk counterparts; hence nanoparticle toxicity mechanisms need to be studied thoroughly.     

Leaching of copper and zinc from spent antifouling paint particles

Leaching of Cu and Zn from a composite of spent antifouling paint particles, containing about 300 mg g⁻¹ and 110 mg g⁻¹ of the respective metals, was studied in batch experiments. For a given set of simulated environmental conditions, release of Cu was independent of paint particle concentration due to attainment of pseudo-saturation, but Zn was less constrained by solubility effects and release increased with increasing particle concentration. Leaching of Cu increased but Zn decreased with increasing salinity, consistent with mechanisms governing the dissolution of Cu₂O in the presence of chloride and Zn acrylates in the presence of seawater cations. Because of complex reaction kinetics and the presence of calcium carbonate in the paint matrix, metal leaching appeared to be greater at 4 °C than 19 °C under many conditions. These findings have important environmental and biological implications regarding the deliberate or inadvertent disposal of antifouling paint residues.     

Which compounds contribute most to elevated airborne exposure and corresponding health risks in the Western Balkans?

A majority of ongoing monitoring of persistent organic pollutants (POPs) is currently focused on chemicals emphasized in the Stockholm Convention. Quantitative detection of other substances (especially those with numerous anthropogenic sources such as polyaromatic hydrocarbons (PAHs)) is, however, also needed since their concentrations are usually several orders of magnitude higher. A goal of this study was to determine how various groups of compounds contribute to total human health risks at the variety of sampling sites in the region of Western Balkan. Distribution of the risks between the gas and particulate phases was also addressed. Results showed that inhalation exposure to organochlorine pesticides (OCPs) does not represent a significant risk to humans, while polychlorinated biphenyls (PCBs) re-volatilized to the atmosphere from contaminated soils and buildings can pose a problem. PCB evaporation from primary sources (currently used PCB-filled transformers or non-adequate storage facilities) generally resulted in much higher atmospheric concentrations than evaporation from the secondary sources (soils at the sites of war destructions). A majority of the human health risks at the urban sites were associated with PAHs. Between 83 and 94% of the cumulative risk at such sites was assigned to chemicals sorbed to particles, and out of it, PAHs were responsible for 99%.     

纳米ZnO/PS薄膜的制备及光降解性能

利用纳米ZnO与聚苯乙烯(PS)高速共混法制备了一种在紫外光下具有自降解性能的复合薄膜.分析表明,经过KH570处理的纳米ZnO与PS通过化学键的方式桥联在一起.TG分析表明,复合薄膜的耐热性较PS有所提高；SEM图像显示0.5 wt％ ZnO在PS薄膜表面分布均匀,经过UV照射后薄膜表面出现光腐蚀现象.复合薄膜紫外光自降解实验表明:0.5 wt％ ZnO/PS薄膜在15W的紫外灯照射下,15d的自降解率为3.715％.     

牛粪堆肥升温菌剂的筛选及其作用机制

以糖、淀粉、蛋白质、纤维素培养基及菌株增殖倍数、菌株性能等为筛选方法,从牛粪低温堆肥中筛选不同原料重要功能菌并组成功能菌剂;以不同类别原料菌及单菌株发酵实验对升温机制进行研究。结果表明,芽孢杆菌、假单胞菌、纤维单胞菌及小孢霉菌等为重要功能菌;菌剂起温快,升温效果好,48 h堆体即由低温进入中温,5 d达到高温,腐熟时间可缩短至约17~18 d;糖功能菌升温效果最为显著,淀粉及蛋白质功能菌次之,纤维素功能菌升温能力较弱;菌株利用各种原料能力越强,增殖速度越快,对升温作用越大。各菌株充分利用基质各成分,紧密协同和促进,是低温堆体发酵升温的主要作用机制。     

纳米二氧化钛复合石墨烯催化剂的制备及处理染料废水

以硫酸钛为原料,采用共沉淀法,制备了一系列纳米二氧化钛复合石墨烯催化剂,采用XRD和FTIR对样品进行表征。通过紫外光照射亚甲基蓝溶液光催化降解实验,研究石墨烯的加入量对TiO2光催化性能的影响,结果表明,TiO2-GO-5具有最佳的光催化性能。在pH=6.00、TiO2-GO-5的投加量为0.070 g/50 mL、光照3 h条件下,100 mg/L亚甲基蓝溶液的脱色率达到最大值为90.52%。     

高含盐水样中悬浮物的准确测定

通过理论分析和大量实验工作，找出了现行国家标准的悬浮物测定方法在测定高含盐污水时的不足之处，并且提出了准确的测定方法。新方法不仅能很好地反映水样的实际状况，而且可以推广应用于各种复杂水样的悬浮物的测定。     

Deposition and Storage of Spheroidal Carbonaceous Fly-Ash Particles in European Mountain Lake Sediments and Catchment Soils

Spheroidal carbonaceous particles(SCPs) are produced only from high temperaturecombustion of fossil-fuels. In mountain lakesystems, they provide an unambiguous indicator ofatmospheric deposition. In order to comparedepositional fluxes of SCPs between mountainareas experiencing various pollutant regimes,intensive bulk deposition sampling was undertakenat five sites across Europe. Catchment soil coresand lake sediment cores were also taken at eachsite to compare SCP storage over the post-industrial period. Atmospheric, sediment and soilSCP data showed similar patterns. Highestcontamination was found in Scotland, Slovakia andSpain with the Austrian site intermediate and themid-Norwegian site least contaminated. A highproportion of accumulated SCPs were found to bestored in catchment soils at each site.Therefore, a significant increase in soilerosion, possibly as a result of future climatechange, could lead to the input of largequantities of catchment stored SCPs and, byimplication, other atmospherically depositedcontaminants to the lake ecosystem.     

Production of radioactive particles for use in environmental studies

This paper presents an aerosol generation technique developed to produce dry aerosol particles of various sizes from aqueous solutions of salt. The technique was tested with sodium chloride, lithium carbonate and uranyl acetate at various aqueous concentrations which produced particles in the size range of 0.13-1.37 microm Mass Median Diameter (MMD). The generated aerosols were acceptably monodisperse with a geometric standard deviation of 1.4-2. Both MMD and Mass Median Aerodynamic Diameter (MMAD) increased significantly (p<0.001) with increased concentration of the salt in solution. The technique can also be used to generate aerosols of different chemical species. The results obtained indicate that the system is convenient for use with various aerosol-forming materials, with a stable particle size distribution being maintained for a long period of steady operation. The technique was successfully applied in wind tunnel studies to simulate the release of submicron radioactive particles and their interception by crops, grass and tree canopies. The relevance and application of the technique in other areas of environmental assessment studies is discussed.